This is how I make my hexagons. There are several ways, but my mother taught me about 25 years ago to English paper-piece and so this is the way I know...
Step 1. Decide on your size.
I worked on the basis that I wanted to replicate the hexagon quilt my mother made. I used to lie on her very scrappy version and find all the rose bits so I decided mine should be mainly rose fabrics. Instead of using the metal templates my father made donkey's years ago, I went online and found a site that offered free hexagon templates that you could print out. I put in the size I wanted, printed it off and then photocopied the hexagons until I could fit as many as possible on one sheet of paper. I then photocopied that page full of hexagons. (This saves paper when you are cutting out your hexagon 'inners'). I remember my mother used old magazines for her 'inners' and that she had 2 templates. One smaller template was for cutting the papers and the bigger one for cutting the fabrics. If you want to make a template or templates you can use template plastic, old x-rays or even a lid off a thin plastic container etc (just watch that your templates don't have rough edges!)
I used an online free graph paper site which I now cannot find, but I still have the original pdf which I downloaded so if you'd like to make the same size hexagons as me, then let me know. Otherwise this site has a free paper template in 2 sizes:
http://www.lizardofoz.com.au/free_stuff/design_papers.aspx
and they also sell papers, template packs etc as do many other sites I am sure...
Step 2. Cut your papers
Step 3. Cut your fabric allowing for a quarter inch seam allowance all around.
If I am fussy cutting, I pin the paper on to the right side of the fabric and cut around moving the pin and paper to the wrong side after cutting.
Step 4. With a pin keeping the fabric in place and with a quarter inch all around, I begin by folding the fabric over the paper on the first edge.
Step 5. Baste your fabric to the papers with a neutral thread (this is in case you leave your basting thread in a long time to avoid colour runs). I do NOT knot the end of my thread, instead I simply back stitch and then continue basting.
(TIP: Use a cheap thread and save your 100% cotton thread for stitching the hexagons together later!)
TIP: If the end of your thread is not knotted then you should find that when you come to remove your basting stitches and papers later it is much easier.
Step 6. Fold your corners sharply.
You want nice neat edges so stop a stitch short, then fold your fabric over the edge and continue basting.
Do this for each corner. At the end back stitch a stitch or two again.
Step 7. Now you are ready to start sewing them together!
(Above you can see I am adding my hexagon to some already sewn together. I pin the new hexagon like that to start ONLY to see how it will fit in with the overall look. Then I pin it as I explain below to stitch it!)Place 2 hexagons right sides together. I pin the edges of the side I am not going to start on.
(Above I am pinning my new hexagon to 2 already sewn together. The same principle applies: you sew 2 together first, then re-pin as you get ready to sew your hexagon to the next one... Does this make sense?)Step 8. Hold your hexagons together, making sure that the edges match together perfectly. Start stitching a quarter of an inch in and then sew back to the beginning edge.
Then sew over those first few stitches towards the pin.
This means you don't need to knot your thread and that your first stitches are secure. I sew very small stitches and continue sewing to the pin. A few stitches before the end, I remove the pin and sew to the end.
Step 9. When you get to the end, do the same and sew over the last few stitches to secure them.
I do this even if I am about to sew another hexagon on straight away! You never know if you may need to unpick or that through wear and tear of your quilt top some stitches may come loose so I sew each end very very well.
Step 10. Ta dah! You are ready to add another hexagon and watch your quilt top grow.
Above you can see that I have sewn both sides of the new hexagon on to the rest. Once you sewn your first 2 together, you will see how easy it is to join them all together and there will be no stopping you!!Step 11. Have fun! Hand work is a great way to truly enjoy those special fabrics!
TIP: Always leave the papers in until you are ready to baste the quilt top, this prevents your top from stretching out of shape.
Please let me know if I have not explained anything clearly. I LOVE English paper piecing and hope you will too.
One of the reasons for the delay is that I wanted to bind it in brown, but I didn't buy enough. I had lots of blue, but I have already bound a quilt in blue (is that a silly reason to want to do brown or what LOL!) I bought the first piece of brown off Ebay and luckily the Ebayer still had some which she kindly listed for me. Unfortunately she put it on a 7-day listing so I had to wait a whole week to bid on it! Never mind, it's here, it's washed and more importantly it's on! Now I just need to hand stitch it down, but I doubt I'll get it done for April as it's a pretty big quilt and I haven't even started the handwork part yet :-)
